Author Topic: X belt vibration leads to waves in the printed part  (Read 1935 times)

ecloud

  • Newbie
  • *
  • Posts: 23
X belt vibration leads to waves in the printed part
« on: April 15, 2015, 08:23:49 PM »
See this video:

https://youtu.be/EgyTjJfUmcE

I guess that's one reason they have trouble with increasing the speed.  But it's interesting that it happens only on the left side of the belt, which does not have a belt tensioner.  On the right side there is a belt tensioner, and no vibration.

anonchik

  • Newbie
  • *
  • Posts: 2
Re: X belt vibration leads to waves in the printed part
« Reply #1 on: April 22, 2015, 06:05:29 PM »
Does it works?

ecloud

  • Newbie
  • *
  • Posts: 23
Re: X belt vibration leads to waves in the printed part
« Reply #2 on: April 23, 2015, 06:00:23 AM »
Does what work?

AndrewLemaitre

  • Newbie
  • *
  • Posts: 18
Re: X belt vibration leads to waves in the printed part
« Reply #3 on: October 29, 2015, 05:42:46 PM »
Hi ecloud,

I noticed the same problem on my Zeus. However, it hasn't been causing any noticeable issues in my parts at all. Did you figure out a solution for the resonance? I think something simple, like a paper clip attached to the belt might solve the issue.

Did you ever take off and replace your belt tensioner? I did a tear down and rebuild of all the axes at one point and had to remove/replace the tensioner. Not sure if the issue was present before that though.